Loading ...
Loading ...
Loading ...
STEP5 • INSTALLTHEMOUNTING PLATETO THEWALL
THE OVEN MUST BE CONNECTED TO
AT LEAST ONE WALL STUD
1. Draw a vertical line on the wall at the center of
the 30" wide space.
Use the mounting plate as the template for the
rear wall. Place the mounting plate on the wall,
making sure that the tabs are against the bottom
of the cabinet. Line up the notch and center line
on the mounting plate to the center line on the wall.
2. While holding the mounting plate with one hand,
draw circles on the wall at holes "A", "B", "C"and
"D". Four holes must be used for mounting.
If the holes are not used, the installation will not
be secure. Installer must use these holes for proper
installation. Use toggle bolts through these holes
unless one of them lines up with a stud.
Use awood screw for studs. See Figure 26.
NOTE: Draw a fifth circle inside area "E", through
one of the holes to match the location of
astud.
For wall vented: The oven requires a rear wall cutout
opening for the rear wall duct and the exhaust
adaptor must be attached to the mounting plate.
See the next page on how to prepare the rear wail
cutout opening and the exhaust adaptor/mounting
plate for wail vented.
3. Drill holes through the circles. If there is a stud, drill
a 3/16" hole for lag screws. Two or preferably
four lag screws at holes "A"and "C", or "B" and "C"
must be used to secure mounting plate to wall.
If there is no stud, drill a 3/4" hole for toggle bolts.
Make sure to use at least I lag screw at holes of
area "E" in a stud, and 4 toggle bolts at holes "A",
"B", "C" and "D" in the drywall or the plaster.
4. Attach the plate to the wall. To use spring toggle
head bolts: Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate and replace
the spring toggle heads to 3/4" past the bolt ends.
Insert the spring toggle heads into the holes in the
wall to mount the bracket. You may pull forward
on the bracket to help in tightening the toggle bolts.
Tighten all bolts. See Figure 27.
Minimum
he
3/1 6" Hole on Studs
3/4" Hole on Dry wall Only
66" i
l I II ForWoU-
| III ente On,y
LT! °7"
I'!pcl_-" _1 o41
;:/I I )t
/ Draw Lines , \
/ on Studs i \
t i _ J t
Support Tab Support Tab
(3 pieces mounting plate)
Figure 26
, Space More Than Wall Thickness
Mounting-_Toggle Wings
Hate f
_ Bolt
End
Wall
Figure 27
15
Loading ...
Loading ...
Loading ...