Loading ...
Loading ...
Loading ...
24
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
1 Make sure that the exhaust hood flapper or louvers move freely.
If you do not have an exhaust hood installed, see Exhaust hood types
on page
16 for information about recommended hood types. We recommend that
you have a professional install the exhaust hood.
2 Connect one end of the exhaust ducting to your dryer, then use duct tape to
secure the ducting to your dryer. The crimped ends of the duct sections must
point away from your dryer. Use a 4 in. (10.2 cm) diameter rigid metal duct.
3 Connect the other end of the ducting to the exhaust hood. Tape all joints,
including at the dryer.
Step 4: Level your dryer
• If your dryer is not level, carefully tilt your dryer just enough to adjust the
leveling feet on the bottom of your dryer. Extend the feet only as much as is
necessary. If the feet are extended too much, your dryer may vibrate.
Step 5: Connect the power cord (U.S. models only)
• Determine whether your electric outlet is a three-wire or four-wire outlet. See
Power outlet types
on page 18.
Important: Before you connect the power cord, review the electric
requirements in Electric requirements
on page 17.
Before testing or operating your dryer, make sure that your dryer is grounded.
See Grounding requirements on page 20.
Level
Tighten
Loosen
Adjustable leg
Loading ...
Loading ...
Loading ...