Documents: Go to download!
User Manual
- User Manual - (English, French, Spanish)
- Installation Instruction - (English)
- About your new thermostat
- Thermostat Operation
- Appendices
Table of contents
User Manual Thermostats
About your new thermostat
Features
- One-touch temperature controls
- Large, clear backlit display is easy to read, even in the dark
- Switchable fan control (auto or continuous fan)
- Displays both room temperature and temperature setting
- Built-in compressor protection
Quick reference to controls
Quick reference to display screen
- Cool On: Cooling system is on.
- Heat On: Heating system is on.
- Em: Emergency heat is on.
- Aux: Auxiliary heat is on.
Thermostat Operation
System switch
The SYSTEM switch can be set to control your heating or cooling system, depending on the season.
- Cool: Cooling system control.
- Off: All systems are off.
- Heat: Heating system control.
- Em Heat: Emergency & Auxiliary Heat control. Compressor is locked out.
CAUTION: EQUIPMENT DAMAGE HAZARD. Do not operate cooling system when outdoor temperature is below 50°F (10°C).
Fan switch
Set the FAN switch to Auto or On.
In “Auto” mode (the most commonly used setting), the fan runs only when the heating or cooling system is on.
If set to “On,” the fan runs continuously
Temperature controls
Press the temperature adjustment buttons until the temperature you want is displayed in the upper right portion of the screen.
Note: Make sure the SYSTEM switch is set to the system you want to control (Heat or Cool).
Built-in compressor protection
This feature helps prevent damage to the compressor in your air conditioning or heat pump system.
Damage can occur if the compressor is restarted too soon after shutdown. This feature forces the compressor to wait for a few minutes before restarting.
During the wait time, the display will flash the message Cool On or Heat On. When the safe wait time has elapsed, the message stops flashing and the compressor turns on.
Appendices
Battery replacement
Batteries are optional if your thermostat was wired for AC power when installed. Install fresh batteries immediately when the REPLACE BATT warning begins flashing.
Even if the warning does not appear, you should replace batteries once a year, or before leaving home for more than a month.
Batteries provide backup power to the display during power interruptions. All settings are permanently stored in memory, and do not require battery power.
In case of difficulty
If you have difficulty with your thermostat, please try the following suggestions. Most problems can be corrected quickly and easily
Display is blank |
|
Heating or cooling system does not respond |
|
Temperature settings do not change | Make sure heating and cooling temperatures are set to acceptable ranges:
|
“Cool On” or “Heat On” is flashing | Compressor protection feature is engaged. Wait 5 minutes for the system to restart safely, without damage to the compressor (see page 8). |
“Heat On” is not displayed | Set the System switch to Heat, and set the temperature level above the current room temperature (see page 7). |
“Cool On” is not displayed | Set the System switch to Cool, and set the temperature level below the current room temperature (see page 7). |
See other models: TH1100DH1004/U CT410B1017/E1 RTH111B1024/E1 THX321WFS2001W/U RTH6580WF1001/U1