Loading ...
Loading ...
Loading ...
INSTALLING AND CARING FOR FILTERS
Electrical Shock Hazard
Disconnect power before removing filters.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
The grease (aluminum) filters should be removed
and cleaned often, at least once a month.
You can order replacements (Part No. 4393862)
from your nearest Sears Service Center.
The charcoal filter cannot be cleaned and
should be replaced every 6 to 12 months. The
replacement schedule for the charcoal filter is
intended mainly for those who install the microwave
hood combination in Recirculation mode.
NOTE: Your microwave hood combination comes
with a charcoal (Part No. 8169645) filter installed
behind the aluminum grease filter. The charcoal fil-
ter helps remove odors and provide clean recircu-
lated air. You may remove the charcoal filter if vent-
ing to the outside.
.... /'8ยข_8C 9
1. Unplug microwave oven or disconnect power.
2. To remove the grease filters (aluminum), push
each filter up on the
side opposite the tab.
Grasp the tab and slide
the filter to the side.
Pull the filter down-
ward. It will drop out.
up
3. To remove the charcoal filters, push the back
of each filter away from
_ you. This will slide the
front of the filter off the
lower lip. Swing the front
of the filter down and
slide the filter out.
4. Soak grease filters in hot water and a mild deter-
gent. Scrub and swish to
remove embedded dirt and
grease. Rinse well and
shake to dry. Do not use
ammonia, corrosive
cleaning agents such as
lye-based oven cleaners,
or place in a dishwasher.
The filterwill turn black or
could be damaged.
5. To replace the charcoal filters, push each filter
to the back of the
opening, between the
upper and lower lips
against the springs.
Swing the front of the
filter up against the
upper lip. Slide the fil-
ter forward while
pushing it up against
the upper lip. The filter
will now be held in
position between the
lips by the spring.
6. To replace the grease filters, slide each filter
into the outer side of
the filter opening. Make
sure you are sliding in
the side of the filter that
does not have the tab.
Hold the tab with your
other hand. Push up
the tab side of the filter
and slide the filter to
the other side of the opening to lock into place.
7. Plug in microwave oven or reconnect power.
NOTE: Do not operate the vent fan without the
grease filters in place.
31
Loading ...
Loading ...
Loading ...