Loading ...
Loading ...
Loading ...
10
49-80759
INSTALLATION INSTRUCTIONS
Installation Instructions
FOR YOUR SAFETY
WARNING ³ Before beginning the
installation, switch power off at the service
panel and lock the service disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the
service panel.
To eliminate the risk of burns or fire due to
reaching over heated surface elements, cabinet
storage located above the surface units should
be avoided. If cabinet storage space is to be
provided, the risk can be reduced by installing a
range hood that projects horizontally a minimum
of 5” beyond the bottom of the cabinets. Cabinet
installation above the cooktop may be no deeper
than 13”.
ELECTRICAL REQUIREMENTS
WARNING ³ This appliance must be
properly grounded.
WARNING ³ To prevent shock,
remove house fuse or open circuit breaker before
beginning installation.
We recommend you have the electrical wiring and
hookup of your range connected by a qualified
electrician. After installation, have the electrician
show you how to disconnect power from the range.
The cooktop conduit wiring is approved for copper
wire connection only, and if you have aluminum
house wiring, you must use special UL approved
connectors for joining copper to aluminum.
You must use a two-wire, three conductor
208/240 VAC, 60 Hertz electrical system. A white
(neutral) wire is not needed for this unit. The
cooktop must be installed in a circuit that does
not exceed 125 VAC nominal to ground.
GROUNDING INSTRUCTIONS:
The bare ground wire in the conduit is
connected to the cooktop frame. Effective
January 1, 1996, the National Electrical Code
will not permit grounding through neutral. If
used in new construction after January 1, 1996
or in a mobile home, recreational vehicle or if
local codes do not permit grounding through
the neutral white lead, attach the appliance
grounding lead (green or copper) to the
residence grounding conductor (green or bare
copper) in accordance with local codes. When
connecting to a 3 conductor branch circuit, if
local codes permit, connect the bare ground
connector lead of the cooktop to the branch
circuit neutral (gray or white in color).
Check with your local utilities for electrical codes
which apply in your area. Failure to wire your
cooktop according to governing codes could
result in a hazardous condition. If there are no
local codes, your cooktop must be wired and
fused to meet the requirements of the National
Electrical Code, ANSI/NFPA No. 70 – latest edition,
available from the National Fire Protection
Association.
You can find them on a nameplate label under
the cooktop.
IMPORTANT SAFETY INSTRUCTIONS
Location of
nameplate label
Loading ...
Loading ...
Loading ...