Loading ...
Loading ...
Loading ...
13
2. Setting up the monitor
2. Press ▲ or ▼ button to select main
menu [PIP / PBP], then press
button.
3. Press ▲ or ▼ button to select [PIP /
PBP Mode], then press button.
4. Press ▲ or ▼ button to select [PIP]
or [PBP].
5. Now you can move backward to set
the [PIP / PBP Input], [PIP Size], [PIP
Position]., or [Swap].
6. Press button to confirm your
selection.
4
MultiView in OSD menu
• PIP / PBP Mode: There are two
modes for MultiView: [PIP] and
[PBP].
[
PIP
]
:
Picture in Picture
Open up a sub-window
of another signal source.
B
A (main)
When the sub source is
not detected:
B
A (main)
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of another
signal source.
A (main) B
When the sub source is
not detected:
A (main) B
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by
side, adjust your devices resolutions as
pop up attention resolution, you will
able to see 2 devices source screen
project to this display side by side
without black strips. Note the analog
signal is not support this full screen in
PBP mode.
• PIP / PBP Input: There are three
different video input to choose as
the sub display source: [HDMI],
[DisplayPort], and [USB C].
Please refer below table for compatibil-
ity of main/sub input source.
SUB SOURCE POSSIBILITY
(xl)
Inputs
HDMI
DisplayPort
USB C
MAIN
SOURCE
(xl)
HDMI
● ●
DisplayPort
● ● ●
USB C
● ●
• PIP Size: When PIP is activated,
there are three sub-window sizes to
choose: [Small], [Middle], [Large].
B
A (main)
Small
Middle
Large
Loading ...
Loading ...
Loading ...