Loading ...
Loading ...
Loading ...
63
3
E
ASE OF USE
a
nd COMFOR
T
V
entilation
Settin
g
the time of the internal clock
Set the clock on the control panel before
programming the deferred switching on of
the heating.
Immediate switchin
g
on of the
h
eat
i
n
g
Before switching on the heating, check that:
- the temperature setting control is in the
"Hot air" position (red).
- the air fl ow setting control is in position 2.
This symbol or the previous stored time and
the number (e.g. 1) corresponding to the
recalled pre-selection are displayed for ten
seconds.
Note: if you wish to recall the other pre-
selected times, press the SET button several
times before the ten seconds have elapsed.
Press this button.
The screen and the associated
indicator lamp come on.
Within ten seconds, press these two setting
buttons until the correct time is displayed.
Press ">" to increase the hours or
"<" to decrease.
Press and hold the button for
more rapid scrolling of the digits.
Readin
g
the time
Press this button.
This indicator lamp comes
on, the time is displayed for
approximately ten seconds.
Press this button.
The screen and the heating
cycle indicator lamp come on
and remain on throughout the
duration of operation.
Switchin
g
on the deferred heatin
g
Switching on can be programmed between
one minute and twenty-four hours in
advance.
You can store up to three different start
times, but programme one deferred start
only.
Note : if you wish to start the heating at a
fixed time each day, simply reprogramme
the stored time each day.
Press this button, the screen
becomes brighter.
Within the ten seconds, press
these two setting buttons to
select the required start time.
Setting of the stored time is
confirmed by clearing of the start
time, display of the pre-selection
number (e.g. 1) and increased
brightness of the screen illumination.
Loading ...
Loading ...
Loading ...