Loading ...
Loading ...
Loading ...
installing the dishwasher _15
02 INSTALLING THE DISHWASHER
STEP 8 LEVELING THE DISHWASHER
1. Open the door and place the level against the top of the
tub on the inside and check if the the dishwasher is level.
If it is not level, rotate the leveling legs at the bottom front
of the dishwasher until the dishwasher is level.
See the fi rst note below for instructions on adusting the
height of the front legs.
2. Use the level to check if the dishwasher is level front to
back, as shown in the fi gure to the right.
If the dishwasher is not level front to back, adjust the height
of the rear leg until the dishwasher is level.
See the second note below for instructions on adusting the
the rear leg.
3. Open the door of the dishwasher and check if both the tub
and door clearances are correct.
If not, rotate the leveling legs on the bottom front of the
dishwasher.
You can aslo check this by placing a level against an inside
front vertical surface of the tub.
If the leveling legs are rotated to the right (counter
clockwise), they are loosened and the front of the
dishwasher is raised. If they are rotated to the left
(clockwise), they are tightened and the front of the
dishwasher is lowered.
You can adjust the leveling legs by a max of 1
6
/
32
"
However, leveling up to the max height is not
recommended.
To adjust the height of a rear leg, turn the T210 Torx (at
the front of the base) to the left to raise the back of the
dishwasher using the proper tool (T20 Torx).
Before you move the dishwasher for installation, make sure to adjust the height of the
legs so the legs are as short as possible. This prevents the legs from breaking. Level the
dishwasher by adjusting the height of the legs after you have the dishwasher in place.
The dishwasher can leak if it’s tilted by more than 1 degree.
If the product is installed unleveled or with the leg missing, the door may not close
completely, causing a leak of steam or water.
CAUTION
CAUTION
DW9900M-00183A-01_EN.indd Sec3:15DW9900M-00183A-01_EN.indd Sec3:15 1/2/2017 12:41:09 PM1/2/2017 12:41:09 PM
Loading ...
Loading ...
Loading ...