Loading ...
Loading ...
Loading ...
888
5. Fasten the custom panel to the door using two wood screws
(provided in installation kit) at each corner.
NOTE: Do not use the same screws that were previously
removed.
6. Press the gasket firmly back into its original position.
7. For 8" (203 mm) or 6¹⁄₄" (160 mm) custom handles, install the
custom handle from the inside/back of the beverage center
door using screws provided with the handle.
Door Closing
Door Closing
Your beverage center has four leveling legs. If your beverage
center seems unsteady or you want the door to close more easily,
adjust the beverage center’s tilt using the instructions below.
1. Plug into a grounded 3 prong outlet.
2. Move the beverage center into its final location.
3. Turn the leveling legs to the right to lower the beverage
center or turn the leveling legs to the left to raise it. It may
take several turns of the leveling legs to adjust the tilt of
the beverage center.
NOTE: Having someone push against the top of the beverage
center takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as easily as
you like. If not, tilt the beverage center slightly more to the
rear by turning both front leveling screws to the left. It may
take several more turns, and you should turn both leveling
legs the same amount.
A. M4 x 14 wood screws (provided in installation kit)
A
A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
Loading ...
Loading ...
Loading ...