Loading ...
Loading ...
Loading ...
666
Custom Handle (optional)
Custom handles are typically attached to the custom overlay
door panel only. There are two custom handle locations provided
on the beverage center where the handle may be attached
through the custom overlay door panel and to the inside of the
beverage center door for enhanced stability. The two locations
provided accommodate popular kitchen cabinet pull/handle sizes
of 8" (203 mm) and 6¹⁄₄" (160 mm).
1. Follow the instructions to make the custom overlay panel.
2. See the following dimension drawings for custom handle
specifications.
3. Drill custom handle holes to match the size of your custom
handle—8" (203 mm) or 6¹⁄₄" (160 mm).
4. Install custom handle before installing overlay panel on
beverage center door.
NOTE: Custom handles that are placed in a different location
(see preceding drawing) or are not the recommended size
(8" [203 mm] or 6¹⁄₄" [160 mm]) need to be installed on the door
panel with countersunk holes, and installed before the custom
overlay door panel has been installed on the beverage center
door.
Electrical Requirements
Before you move your beverage center into its final location,
it is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 volt, 60 Hz., AC only, 15– or 20–amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your beverage center be provided. Use an
outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, unplug beverage center or disconnect
power.
INSTALLATION
INSTRUCTIONS
Unpack the Beverage Center
Remove the Packaging
■ Remove tape and glue residue from surfaces before turning
on the beverage center. Rub a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
■ Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your beverage center.
For more information, see “Beverage Center Safety.”
A. 8" (203 mm) handle holes
B. 6" (160 mm) handle holes
C. Drill holes using a
³⁄₁₆
"
(4.5 mm) drill bit (2 holes)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
Loading ...
Loading ...
Loading ...