Loading ...
Loading ...
Loading ...
!;0=,?4929>?=@.?4:9> $,10?D9>?=@.?4:9>:9>@80=$@;;:=? %=:@-70>3::?492%4;>
01:=0D:@.,771:=>0=A4.0N
"
=:-708 ":>>4-70,@>0> (3,?%::
$@/>49?30?@- Correct detergent • Use only automatic dishwasher detergents to avoid sudsing. ,>.,/0
K
wasn’t used Automatic Dishwashing Detergents have been approved for use in all
GE dishwashers.
• To remove suds from the tub, open the dishwasher and let suds dissipate.
Close and latch the dishwasher. Pump out water by touching the
$%#%#$%pad once; then 30 seconds later, touch the
$%#%#$%pad again. Repeat if necessary.
Rinse agent was spilled • Always wipe up rinse agent spills immediately.
Detergent placed in manual • Use SmartDispense
™
or the manual detergent dispenser, but not both.
detergent dispenser and
SmartDispense
™
dispenser
0?0=209?701?49 Dishes are blocking the • Reposition the dishes, so the water from the lower spray arm can
/4>;09>0=.@;> detergent cup or flush the detergent cup or the outlet on the SmartDispense
™
system.
SmartDispense
™
outlet See the 7),16/<0-,1;0?);0-:section.
(,?0=49?30 Cap not tightened after • Use a turkey baster to remove as much water as possible from the
$8,=?4>;09>0
L
filling the dispenser SmartDispense
™
dispenser and refill it as normal. Be sure to tighten
/4>;09>0= the cap fully to prevent water from entering the dispenser.
7,.6:=2=,D Aluminum utensils have • Remove marks with a mild, abrasive cleaner.
8,=6>:9/4>30> rubbed against dishes
4>30>/:9P?/=D Low inlet water temperature • Make sure inlet water temperature is at least 120°F.
• Select %#*
• Use !%$%#%, !%($or % options.
• Select a higher cycle, such as %%#, $ ($ or "!%$" $.
Rinse agent dispenser is empty • Check the rinse agent dispenser and fill as required.
:9?=:7;,907 =0>;:9/0/ Door latch may not be properly • Make sure the door is firmly closed.
?:49;@?>-@?/4>3B,>30= seated
90A0= 14770/B4?3B,?0=
Water valve may be turned off • Make sure water valve (usually located under the sink) is turned on.
$?,490/?@-49?0=4:= Some tomato-based foods can • Use of the # $! * cycle after adding the dish to the load
cause reddish stains can decrease the level of staining. GE recommends ,>.,/0
K
"7,>?4.::>?0=to help remove these types of stains.
Tea or coffee stains • Remove the stain by hand, using a solution of 1/2 cup bleach
and 3 cups warm water.
(#
Before cleaning interior, wait at least 20 minutes after a cycle for the
heating elements to cool down. Failure to do so can result in burns.
'#%
Antes de limpiar el interior, espere por lo menos 20 minutos después
de un ciclo para que los elementos calentadores se enfríen. No hacerlo
puede provocar quemaduras.
An overall yellow or brown film can
• A special filter in the water supply line is the only way to correct
be caused by iron deposits in water
this problem. Contact a water softener company.
White film on inside surface— • GE recommends ,>.,/0=D>?,770,=
K
to help prevent hard water
hard water minerals mineral deposits from forming.
• Run dishwasher with citric acid to remove mineral deposits. Citric acid
(Part number: WD35X151) can be ordered through GE Parts. See back
cover for ordering information.
4>3B,>30=B:9P?=@9 Fuse is blown or circuit breaker • Replace fuse or reset circuit breaker. Remove any other appliances from
is tripped the circuit.
Power is turned off • In some installations, the power to the dishwasher is provided through a
wall switch, often located next to the disposer switch. Make sure it is on.
Control panel is locked • Unlock control panel. See page 7, 9 or 11.
Reboot your control • Turn off power to the dishwasher (circuit breaker or wall switch) for
30 seconds; then turn back on.
20
Loading ...
Loading ...
Loading ...