Loading ...
Loading ...
Loading ...
11
:9>@80=$@;;:=?%=:@-70>3::?492%4;>!;0=,?4929>?=@.?4:9>$,10?D9>?=@.?4:9>
SPEED CYCLE 7.5 gal., 35–70 min.
(on some models)
This cycle is for everyday dishes and glassware.
RINSE ONLY 2.5 gal., 10 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
!%#01;,1;0?);0-:1;-9=188-,?1<0)4-)6"-6;7:
H
?1<0)=<75)<1+<-58-:)<=:-+76<:74<0-:-.7:-+A+4-
4-6/<0)6,<15-5)A>):A,-8-6,16/76;714)6,<-58-:)<=:-+76,1<176;
!%64A<0-$ ($ +A+4-0);*--6,-;1/6-,<75--<<0-:-9=1:-5-6<;7."-+<176".7:;714
:-57>)4)6,;)61<1B)<176-..1+)+A
!;?4:9>
#0-41/0<)*7>-<0-;-4-+<-,8),?144*-! <716,1+)<-?01+0 %)%# 0);*--6;-4-+<-,
STEAM For use with heavily soiled and/or dried-on, baked-on soils. This option &$%be selected "#!#
(on some models)
to starting the cycle. #0-$%78<176),,;516=<-;<7<0-+A+4-<15-
HEATED DRY When %#*is off, dishes will air dry.
1/0<
HEATED DRY Turns the heater on for faster drying. This will extend the total cycle time between
1/0< 8 and 38 minutes depending on the cycle selected. !%%#*cannot be
selected with # $! *cycle.
LOCK (7=+)647+3<0-+76<:74;<78:->-6<)6A;-4-+<176;.:75*-16/5),-:A7=+)647+3
<0-+76<:74;).<-:A7=0)>-;<):<-,)+A+4-
014,:-6+)667<)++1,-6<)44A;<):<,1;0?);0-:*A<7=+016/8),;?1<0<01;78<176;-4-+<-,
To unlock the dishwasher controls, touch and hold the %#*pad for 3
seconds. The light above the ! pad will turn off. To lock the dishwasher control,
touch and hold the %#*pad for 3 seconds. The light above the ! pad
will turn on.
ADDED HEAT When selected, the cycle will run with heating element on longer and may increase
cycle times to improve both wash and dry performance.
!% Cannot be selected with # $! *cycle.
DELAY HOURS You can delay the start of a wash cycle for up to 9 hours. Touch the *!&#$ pad
to choose the number of hours you want to delay the start of the cycle; then touch
$%#%#$%. The machine will count down and start automatically at the correct time.
Touching $%#%#$% a second time will cancel the *$%#% selection.
!% If you forget to fully close the door, a reminder signal will beep until you do so.
RESET To change a cycle after washing starts, touch the $%#%#$% pad to cancel the
cycle. For some models, the $%#%#$% light will flash while the water is pumped
out. This takes approximately 90 seconds. The door must be closed to complete pump
out. When the light stops flashing, the dishwasher can be reprogrammed and
restarted. Buttons will not respond during pump out.
For other models, the $%#%#$% will turn off and the drain pump will pump
water out of the dishwasher for 90 seconds and then turn off. Cycle selection and
option ’s will remain on, and buttons will respond during pump out. If the
$%#%#$% is pressed while the dishwasher is in pump out, the $%#%#$%
will turn on and the dishwasher will start a new wash cycle
;;74,9.0>.:8
$%#%
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
$%#%#$% pad once to begin the cycle. Water begins to fill the dishwasher, and approximately 60
seconds later the wash action begins.
!%The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the
dishwasher door is fully closed, the control panel lights will display the last settings you selected.
If you don’t want to change any of the settings, simply touch the $%#%#$%pad to begin the cycle.
If the door is closed, the indicator lights will turn off if the $%#%#$% pad is not selected within two
minutes. To activate the display, open and close the door or press any pad.
Also, if a power failure occurs, !#($and %#*will automatically be programmed.
Make any new selections and touch the $%#%#$%pad to begin the cycle.
The light will illuminate and a double beep will sound when a wash cycle is complete. On some
models, the light will turn off when the door is opened. On other models, the light will
remain on until the door is opened and then relatched or until any keypad is pressed while the door is
latched shut.
Loading ...
Loading ...
Loading ...