Loading ...
Loading ...
Loading ...
4
Chapter 1 Connections and Setup
Before Initial Setup
Protect Against Power Surges
• Connect all components before you plug any power cords into the wall outlet or power strip.
• NEVER plug your TV into an outlet that is controlled by a wall switch.
• Turn off the TV before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions.
Safety Information
• Prevent TV from overheating with a good ventilation area.
• Don’t block ventilation holes on any of this TV. Arrange the TV so air can circulate freely.
• Don’t stack object onto this TV.
• If you place the TV on a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplier to the TV, place it on the top shelf so the heated air won’t
harm the TV.
Avoid Audio Interference
• Position cables properly; insert each cable rmly into the designated jack.
• Route all cables down one side of the back of the TV instead of straight down the middle.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables.
• Keep twin lead cables away from audio/video cables.
Avoid Direct Light
Don’t place the TV where sunlight or room lighting is directed toward the screen. Use soft or indirect lighting.
Check Supplied Parts
Check that the following parts were packed with your product.
• 1 Remote Control and 2 AAA Batteries
• Power Cord
• User’s Guide
• Quick Start Guide
• Parts for Base Stand Assembly :
• Base Stand
• (M5 x 12) Screw x 4, (ST5 x 15) Screw x 3 - only for models of 48"/55"
• (M4 x 12) Screw x 4, (ST4 x 15) Screw x 3 - only for models of 32"/39"
• Support Bracket x 2, (ST3 x 8) Screw x 2 - only for models of 48"/39"
Replacing your remote
If you need to replace your remote, visit www.tclusa.com. A shipping and handling fee, and the appropriate sales tax, will be charged
upon ordering. Have your Visa or MasterCard ready.
Loading ...
Loading ...
Loading ...