Loading ...
Loading ...
Loading ...
2 Add
water supply line I
NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base, frame
or motor.
Connect the 3/8"compression fitting to the water supply line
prior to installing the unit into the cabinet opening. Attach so
that the 3/,,, connection is facing upward as shown above.
Copper tubing only: Put the tubing into the 90 ° elbow fitting as
far as it will go (the copper tubing bends and kinks easily). Slide
the nut and ferrule forward and start the nut onto the elbow
threads.
Flexible braided connection: Secure nut to elbow using %" open
ended wrench or adjustable wrench.
NOTE: Do not use Teflon ®ttape with compression fittings.
Be sure rubber washer is properly seated in fitting. Slide the
3/,,,fitting up to the valve and hand tighten to avoid cross-
threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
1/, to 1/2turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
t®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
i¸¸k
Place paper towel under 90 ° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
Place towel under drain hose to catch any water in drain hose.
Place the small drain hose clamp onto the small end of the drain
hose. Push the new drain hose into the black drain hose
connector up to the drain hose stop.
Using pliers, squeeze open the small drain hose clamp and slide
onto connector between stops.
19
Loading ...
Loading ...
Loading ...