Loading ...
Loading ...
Loading ...
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (included with
power supply cord kit).
Tighten strain relief screws to secure cord.
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 1/4"hex head socket, nut driver or
Torx® T20®screwdriver and previously removed screw to secure
cover.
NOTE: Do not plug into outlet until instructed to do so.
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed (you will
need to measure the lowest point on the underside of the
countertop and the highest point on the floor). Refer to
"Dishwasher Height Adjustment Chart" for wheel position and
the number of turns needed.
331/2" (85[1 Cm)RemOved All the Wayup
34 (86.4 cm) 1 . 10
m
1 H
34Y4 (87.0 cm) 2 . 5
341/2'! (87,6 cm) I. 0
NOTE: If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to fit into a 331/2''
(85.1 cm) high cabinet opening, but the dishwasher will be more
difficult to move. (Measurements are approximate. Wheels and
legs are preset at the factory for 341/2'' [87.6 cm].)
Wheel
Turn both leveler legs to the same height. Put wheels in the
required position determined from "Dishwasher Height
Adjustment Chart."
14
Loading ...
Loading ...
Loading ...