Loading ...
Loading ...
Loading ...
7
Before Use & Using Your Steam Cleaner
Before Use
3
4
Filling Steam Cleaner with Water
WARNINGS
•
Carefully read all instructions before removing Boiler Cap.
•
Always switch off the appliance and be sure it has cooled before lling
the Boiler.
Connecting Extension Tube(s)
• Attach one Extension Tube to Steam Gun on Flexible Steam Hose.
• To attach Extension Tubes together, press down the locking button
while sliding Tubes together. Be sure button and hole line up and button
locks in place. To disconnect, press the locking button and pull the two
sections apart.
WARNING:
Always ensure steam trigger is off and not steaming
when attaching an accessory to the unit.
Follow these instructions to avoid overlling the Boiler.
• Be sure the appliance is switched off at the Power Switch and unplug the
appliance from the power outlet.
• Carefully remove the Boiler Cap by
turning it counter-clockwise.
• Pour in a maximum of 1.2 litres / 2
pints of water using the Filler Funnel
provided. Do not overll the Boiler,
excess water in the Boiler will be
ushed out of the unit, resulting in wet
oors or wet surfaces when cleaning.
Dry steam will only emit if the Boiler is not overlled.
• Replace the Boiler Cap by turning it clockwise.
Do not over-tighten the Boiler Cap, nger tight is
sufcient.
• Plug electrical cord into a 3-prong grounded
power outlet.
• Turn on the Power Switch.
• The Steam Cleaner will heat up, produce steam and the Boiler will
become pressurised.
• When the green Steam Ready Light turns on the Steam Cleaner is ready
to use. Note: the green Steam Ready Light may turn on and off during
use, this is normal and not a fault.
• If using cold water, heating time is about 6-7 minutes. Using hot water will
reduce the heating time.
NOTE: Do not turn on Steam Cleaner if Boiler is empty.
*IMPORTANT*
Use ordinary tap water. Use distilled or demineralized water if tap water is too
hard. DO NOT add detergents, perfumes, oils or other chemical substances.
Using Your Steam Cleaner
Max. 1.2l
Loading ...
Loading ...
Loading ...