Loading ...
Loading ...
Loading ...
DANGER: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades (G). If overtightened, blades (G) may crack
and break.
Place one blade plate (J) under blade (G), aligning
holes. Then, insert one motor screw/washer (BB)
into one of the holes at the end of the blade (G),
turning until the motor screw (BB) comes through
the other side of the blade (G). Repeat with the
other motor screw/washer (BB).
Align the protruding ends of the motor
screws/washers (BB) with the corresponding holes
on the underside of the motor housing (D). Tighten
both motor screws/washers (BB).
Repeat Step 2 for the other two blades (G).
DANGER: To reduce the risk of personal
injury, make sure all blades (G) are completely
secure before proceeding.
11
FINAL INSTALLATION
2.
2
G
J
D
BB
Hardware Used
Blade Screw/Washer
x 6
BB
Locate two canopy mounting screws (K) on
underside of mounting bracket (C) and remove
canopy mounting screw (K) closest to the open end
of the mounting bracket (C). Partially loosen the
other canopy mounting screw (K). Lift canopy (B) to
mounting bracket (C). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (K) and push up. Twist canopy (B) to lock.
Re-insert canopy mounting screw (K) that was
removed, then tighten both canopy mounting
screws (K).
Use arrows on inside of canopy cover (H) to locate
knobs on center ring of canopy cover (H). Slide
canopy cover (H) up to canopy (B), aligning knobs
on canopy cover (H) with openings in bottom of
canopy (B). Press up gently but firmly on canopy
cover (H) until you hear it snap onto the bottom of
the canopy (B) and then turn canopy cover (H)
clockwise about 1/2 in.
1.
1
K
B
Knobs
H
Loading ...
Loading ...
Loading ...