BE469WKVCAM716 User Manual

Loading ...

ENGLISH

5e Test bolt alignment.

1. Close the door.

2. Insertaatheadscrewdriverintotheslotinthebolt,asshown.

3. Rotate the screwdriver toward the door edge to extend the bolt into the hole in the frame.

Thisoperationshouldbesmooth.Youshouldbeabletorotatethescrewdriver90˚,fully

extending the bolt.

4. Iftheoperationwasnotsmooth,oriftheboltdidnotfullyextend,adjustyourframeand/

or door preparation. Go to answers.schlage.com for further instructions.

5.Retract(unlock)theboltbeforecontinuingtostep6.

Retract the bolt

before continuing

tostep6.

CAUTION

Test from the inside to

avoid being locked out!

If you can rotate the

screwdriver a full

90˚,thentheboltis

fully extended.

6 Install the Touchscreen Assembly.

6a Install the Touchscreen on the outside of the door.

L The clips snap into the crossbore (see step 3 on page 5) to assist in holding the

keypad on the door.

L The Touchscreen Assembly should install smoothly. If it does not, check that the bolt is set

to the correct backset (see step 5a on page 6).

Clips snap into

the crossbore.

Align the tab

with the notch.

Route the cable

under the bolt.

L NOTE:Ifyouhavea1Z\x” (38 mm) crossbore (see step 3 on page 5), please see

Spacer Removalonpage15.

Loading ...

User Manual - Page 8