Loading ...
Loading ...
Loading ...
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows .
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows
the desired delay time.
3. Touch the Start/Pause button again
to start the new countdown.
10.5 Starting a programme
WARNING!
Make sure that the
detergent dispenser is firmly
closed, otherwise
programme won't start.
Touch the Start/Pause button to start
the programme.
The related indicator stops flashing and
stays on.
In the display, the indicator of the
operating phase starts flashing.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.6 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pause
button, the maximum declared load
indicator goes off, the indicator
flashes, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
comes on and the indicator
flashes, the drum rotates shortly.
2. The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
At the end of the load detection, if
laundry load is below the maximum
declared weight for selected
programme, the display shows the
new programme duration. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
is
steady on and the indicator is
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
button to start
the programme again. The ProSense
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
www.aeg.com
34
Loading ...
Loading ...
Loading ...