Loading ...
Loading ...
Loading ...
6
Two optional accessories are available for this oven.
1. Charcoal Filter (RK-240). This is required when hood exhaust is recirculated. See Charcoal Filter on page 24.
If dealer does not stock this item, it can be ordered by calling 1-800-BE-SHARP (237-4277).
2. FillerPanelKit.Forusewhentheovenisinstalledina36-inchor42-inchwideopening.Themetalllerpanels
come in 3-inch wide pairs. One set is needed for a 36-inch opening and 2 sets for a 42-inch opening. White and
black are available.
To purchase contact: Sharp Electronics Corporation
Customer Assistance Center
Sharp Plaza Blvd
Memphis, Tennessee 38193
Phone: 1-800-BE-SHARP (237-4277)
OPTIONAL ACCESSORIES
Openthebottomofthecarton,bendthecartonapsbackandtilttheovenovertorestonplasticfoampad.Lift
carton off oven and remove all packing materials, WALL and TOP CABINET TEMPLATE, Turntable, and Turntable
Support. SAVE THE CARTON AS IT MAY MAKE INSTALLATION EASIER.
1. Remove the feature sticker from the outside of the door, if there is one.
2. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right side
wall of the oven cavity. Check to see that there is a WALL TEMPLATE and TOP
CABINET TEMPLATE. Read enclosures and SAVE the Operation Manual.
Check the oven for any damage, such as misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not operate the oven and contact
your dealer or SHARP AUTHORIZED SERVICER. See Installation Instructions for
more details.
UNPACKING INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk
of electric shock by providing an escape wire for the electric current.
WARNING - Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The oven is equipped with a 3-prong grounding plug. DO NOT UNDER ANY CIRCUM-
STANCES CUT OR REMOVE THE GROUNDING PIN FROM THE PLUG.
The Power Supply Cord and plug must be connected to a separate 120 Volt AC, 60
Hz, 15 Amp, or more branch circuit, single grounded receptacle. The receptacle should
be located inside the cabinet directly above the Microwave Oven mounting location.
NOTE:
1. If you have any questions about the grounding or electrical instructions, consult a
qualiedelectricianorserviceperson.
2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal injury resulting from
failure to observe the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven
is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position
and signal of receiving antenna.
ELECTRICAL GROUNDING INSTRUCTIONS
TINSEB391WRRZ_rev 2_R-1514.indd 6 4/19/17 2:27 PM
Loading ...
Loading ...
Loading ...