Loading ...
Loading ...
Loading ...
23
EXTERIOR
The outside surface is precoated steel and plastic.
Clean the outside with mild soap and water; rinse and
dry with a soft cloth. Do not use any type of household
or abrasive cleaner.
DOOR
Be careful with the edge of the oven door as it is glass
and could chip or break. Wipe the window on both sides
with a damp cloth to remove any spills or spatters.
Metal parts will be easier to maintain if wiped frequently
with a damp cloth. Avoid the use of spray and other
harsh cleaners as they may stain, streak or dull the
door surface.
Stainless Steel Trim (R-1514)
The exterior should be wiped often with a damp cloth
and polished with a soft dry cloth to maintain its beauty.
There are also a variety of products designed especially
for cleaning and shining the stainless exterior of the
oven. We recommend that the cleaner be applied to a
soft cloth and then carefully used on the stainless exte-
rior rather than sprayed directly onto it. Follow package
directions carefully.
TOUCH CONTROL PANEL
Wipe the panel with a cloth dampened slightly with
water only. Dry with a soft cloth. Do not scrub or use
any sort of chemical cleaners. Close door and touch
STOP/CLEAR.
INTERIOR
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and set-
ting of spills or spattering. To clean the interior surfaces,
wipe with a soft cloth and warm water. DO NOT USE
ABRASIVE OR HARSH CLEANERS OR SCOURING
PADS. For heavier soil, use baking soda or a mild soap;
rinse thoroughly with hot water. The rack can be cleaned
with hot soapy water, rinsed and dried.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the oven.
To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100%
power. Allow to set in oven until cool. Wipe interior with
a soft cloth.
CLEANING AND CARE
TURNTABLE/TURNTABLE
SUPPORT
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and non-abrasive
scouring sponge. They are also dishwasher-proof. Use
upper rack of dishwasher. The turntable motor shaft is
not sealed, so excess water or spills should be wiped
up immediately.
WAVEGUIDE COVER
The waveguide cover is located on the right side wall of
the oven cavity. It is made from mica so requires special
care. Keep the waveguide cover clean to assure good
oven performance. Carefully wipe with a damp cloth any
food spatters from the surface of the cover immediately
after they occur. Built-up splashes may overheat and
causesmokeorpossiblycatchre.DO NOT REMOVE
THE WAVEGUIDE COVER.
GREASE FILTERS
Filters should be cleaned at least once a month. Never
operatethefanorovenwithouttheltersinplace.
1. Pull down slightly on the tab toward the front of
theovenandremovethelter.Repeatfortheother
lter.
2.Soak the lters in a sink or dish pan lled with
hot water and detergent. DO NOT use ammonia or
otheralkali;theywillreactwiththeltermaterialand
darken it.
3. Agitate and scrub with a brush to remove embedded
dirt.
4. Rinse thoroughly and shake dry.
5. Replacebyttingthelterbackintotheopening.
Greaselter
Tab
Disconnect the power cord before cleaning or leave the door open to inactivate the oven during cleaning.
TINSEB391WRRZ_rev 2_R-1514.indd 23 4/19/17 2:27 PM
Loading ...
Loading ...
Loading ...