Loading ...
Loading ...
Loading ...
User instructions
16
"Flexi Tabs
"
(on some models only)
The option is optimised for use of detergents which are complete with
salt and rinse aid, known on the market as, "triple action", etc. With this
option activated, any salt and rinse aid If you wish to use detergents
which already contain salt and rinse aid already in the dishwasher will
not be used.
With short programs, because there is less time for them to dissolve,
tablets may fail to wash effectively and undissolved residues may be left.
Powder detergents are more suitable for these programs.
- N.B.: even with the "Flexi Tabs" option selected, the
regenerating salt/rinse aid lights will still stay on if their
containers are empty.
IMPORTANT: when no longer required, the option must be disabled
(the light goes out).
If the water hardness has been set on a value above H3, and the “Flexi
Tabs” option is activated, the relative light flashes, warning of a setting
error. Integrated products are not suitable for use with very "hard" water;
this does not prevent the use of the option, but the washing results
might not be of the best.
SPREAD HALF LOAD
Suitable when there are not many dishes to be washed, it saves energy
and reduces the program duration. Place dishes in both baskets then
load the detergent dispenser than less than the normal amount for a full
load.
PROGRAM DELAY
The PROGRAM DELAY button can be pressed to delay the start of the
washing program by from 1 to 12/24 hours depending on the model. This
option allows the dishwasher to be operated at the time of day of the user's
choice. The first time the PROGRAM DELAY button is pressed the option
light comes on and 1:h appears on the DISPLAY (9). The button can then
be pressed again, to set the delay required (
2:h, 3:h
, … etc.). If no button is
pressed for a few seconds, the DISPLAY (9) shows the time left (time
remaining) to the end of the selected program (e.g.
5:40
, duration of the
washing cycle + program delay). When the user confirms the program start
(read the relative section) a prewash will be carried out, after which the
PROGRAM DELAY set will begin, and the time remaining on the DISPLAY
will gradually be counted down. At the end of the delay set, the option light
goes out and the washing cycle starts.
• N.B.: It is not possible to select the PROGRAM DELAY option once
the cycle has begun.
Loading ...
Loading ...
Loading ...