Loading ...
Loading ...
Loading ...
4
NS-SB212 Soundbar Home Theater Speaker
www.insigniaproducts.com
Installing or replacing the remote control
battery
To install or replace the remote control battery:
1 Open the battery cover latch on the remote
control.
2 Remove the old battery (if necessary) and insert
the new 3V lithium battery (CR2025) into the
battery tray. Match the polarity of the new
battery with the plus sign (+) in the battery tray.
3 Slide the battery tray back into the battery
compartment until it clicks into place.
Using the remote control
To use the remote control:
1 Remove the plastic tab from the battery
compartment before using the remote control
for the first time.
2 Point the remote control directly at the IR sensor
on the front of the soundbar. You must be
within approximately 23 ft. (7 m) of the
soundbar.
Setting up your soundbar
Mounting the soundbar
You can use two screws (not included) to hang the
soundbar on the wall opposite your listening
location.
You can also set up the soundbar on a flat surface.
To mount your soundbar on a wall:
1 Select a location close to your TV and directly in
front of the viewing/listening position. For best
sound quality, choose a location where sound
waves are not blocked by furniture or other
obstacles.
2 Tape the supplied wall mount template card to
the wall temporarily. The template shows you
where to locate the two screw holes.
3 Drill two holes on the wall where the template
indicates.
4 Secure two screws (not included) to the wall in
the holes you just drilled. The screws must
protrude from the wall by about 1/4”. The screw
width must be about 3/16” and the screw head
must be approximately 1/4” to 3/8”.
Cautions
• The battery should not be exposed to excessive
heat, such as sunshine, heat registers, or fire.
• Battery chemicals can cause a rash. If the battery
leaks, clean the battery compartment with a
cloth. If chemicals touch your skin, wash
immediately.
• Make sure that the battery is disposed of
correctly. Do not burn or incinerate.
Notes
• Do not mix old and new batteries.
• Remove the battery when the charge is
depleted.
• If the remote control is not going to be used for
an extended period of time, remove the battery.
Cautions
• Do not spill water or any liquid on the remote
control.
• Do not place the remote control on a wet
surface.
• Do not place the remote control in direct
sunlight or near sources of excessive heat.
• If you are not going to use the remote control
for a long time, remove the battery to avoid any
damage that may be caused by leakage and
corrosion.
Pull
Squeeze
IR Sensor
Warning
Improper installation can result in serious injury or
damage to your soundbar. If necessary, seek the
assistance of a professional.
Cautions
• If you are installing screws into wallboard or
concrete, use wall anchors designed for that
type of surface.
• If the soundbar is not mounted securely, there is
a possibility that the soundbar could fall.
16 inches (406 mm)
Approx. 1/4 in. (6-8 mm)
Wall
NS-SB212_12-0388_MAN_EN_V2.book Page 4 Tuesday, April 17, 2012 1:07 PM
Loading ...
Loading ...
Loading ...