Loading ...
Loading ...
Loading ...
20
Oven Racks
CAUTION
To prevent damage, do not leave the oven racks inside
the oven during the self clean cycle.
The oven racks are chrome-plated. To clean, apply a
solution of detergent and hot water. To clean heavy
soil, use the rough side of a sponge or a scouring
pad with plenty of water, or use a solution of 1 cup
ammonia to 2 gallons of water.
Convection Filter (Oven)
WARNING
• The convection filter is made of stainless steel.
Remove it only when it is cool.
• Re-install the filter before cooking in the oven again.
Failure to do so will expose the convection fan blade
that rotates at high speed during convection modes.
Convection Filter Removal and Cleaning
• Remove the filter regularly for cleaning. A
clogged filter will reduce the effectiveness of
convection cooking. Soak it in hot soapy water.
Dry it completely before re-installing.
• To reinstall, orient the filter so that the mounting
clips are towards the rear of the oven, open end
down. Hook the mounting clips over the top of
the horizontal edge across the opening.
Care and Cleaning
Replacing the Oven Light
WARNING
• To prevent an electrical shock hazard and/or personal
injury, make sure that power to the range has been
disconnected and that the light fixture is cool before
replacing the light bulb.
• Always ensure that the lens cover is in place when
using the oven. The lens cover protects the bulb
from breakage caused by high oven temperatures or
mechanical shock.
• Replacing the lens cover without lining up the cutout
with the light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
Replacing a Light Bulb
Light bulb replacement is considered a homeowner
maintenance operation. If the light does not work,
before replacing it, please consult the Problem
Solution Guide on page 21.
1. Replace the light bulb only with Dacor part
number 108774. See page 23 for ordering
information. IMPORTANT: Do not touch the
replacement halogen light bulb with your fingers.
Halogen bulbs are sensitive to the oils from your
hand. The oils from your hand will stick to the
bulb and may cause it to burn out faster than
normal.
2. Disconnect the power cord from the electrical
outlet.
3. Remove the rack support in front of the light.
4. Hold your hand under the lens for support and
gently pry it loose using a spatula or table knife.
Pull the lens
cover straight
out.
5. Grasp the old
bulb and pull it
straight out of
the socket.
6. Using a glove,
insert the new
bulb into the
socket.
7. As you reinstall
the lens cover,
line up the
cutout on the
inside rim with the light socket. Gently press it
into its original position.
8. Replace the rack support and reconnect the
power cord.
Clips on back
of filter
Horizontal
edge
Light
fixture
Light
socket
Lens
Lens cutout
Bulb
Loading ...
Loading ...
Loading ...