Loading ...
Loading ...
Loading ...
15
ArtNo.311-0033 Wok burner details FSD
A
B
C
D
E
ArtNo.311-0016 Fitting the burner inner head
A
B
The Wok Burner
When reassembling the wok burner (Fig. 5.2) turn over the
large base ring and nd the ‘D’ shaped area (Fig. 5.3). Turn
the head until the ‘D’ matches the one on the burner base.
Flip the burner over once again and place it on the burner
base.
To t the small inner burner, nd the larger electrode notch
in the burner rim. Line this up with the ignition electrode and
place the inner burner on the large base ring (Fig. 5.4).
Now t the two burner caps, making sure that they are seated
properly.
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.
Griddle
Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
If the griddle is washed in a dishwasher then some
dishwasher residue may appear on the back. This is normal
and will not aect the performance of your griddle.
The Wok Cradle
Recommended cleaning materials are hot soapy water, a
moistened soap pad, cream cleaner or nylon scourer.
Oven and Divider
Clean the oven and divider with a proprietary oven cleaner,
suitable for enamel.
IMPORTANT: Before cleaning the divider make sure to
remove the silicon sealing strip from the front edge – some
oven cleaners can damage the seal. Remove the strip by
gently pulling both ends to release the hooks holding it in
place.
Control Panel and Oven Doors
Avoid using any abrasive cleaners including cream cleaners.
For best results use liquid detergents.
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
Wipe with a clean dampened cloth then polish with a dry
cloth. The oven doors should only be cleaned with a soft cloth
wrung out in clean hot soapy water.
Removing the Oven Door Outer Panel
The outer door panel can be removed so that the inside of
the glass can be cleaned. Open the door and remove the
2 screws in the inside face (Fig. 5.5). With the door closed,
remove the 3 screws in the underside of the door.
Using the handle, carefully lift the door away.
Ret in reverse.
A – Inner burner cap, B – Outer burner cap, C – Inner burner head,
D – Outer burner head, E – Wok burner base
A – Electrode notch, B – Ignition electrode
ArtNo.271-0009 - 90 Prof+ FX - Cleaning the door glass
Fig. 5.2
Fig. 5.3
Fig. 5.4
Fig. 5.5
Loading ...
Loading ...
Loading ...