Loading ...
Loading ...
Loading ...
5
CRUSHING ICE
Start with half to threequarters of a cup of ice, or 4 to 6 cubes and add 15ml of fresh
cold water.
Put the lid on the blender, then:
1. Turn the speed control to Y for a second or so then release it.
2. Check the state of the ice.
3. Repeat till the ice is the consistency that you need.
USING THE MILL
1. Turn the mill upside down and unscrew the collar.
2. Remove the blade unit and seal.
3. Put the ingredients into the bowl (dry ingredients only).
4. Lower the blade unit and seal on to the bowl.
5. Screw the collar on to the bowl and tighten rmly.
6. Turn the mill right way up and lower it onto the motor unit. Turn it clockwise to
lock it in place.
7. Turn the speed control to Y in short bursts till you achieve the size of grind
you want.
8. Let the speed control return to O, and wait till the blades stop moving
9. Turn the mill anti-clockwise to unlock it then lift it o the motor unit.
10. Turn the mill upside down.
11. Tap the mill a couple of times to move all the ground ingredients into the bowl.
12. Unscrew the collar and remove the blade unit and seal.
13. Empty the bowl.
OVERLOAD PROTECTION
This appliance is tted with a device to protect it in the event it becomes overloaded
or overheats. If the appliance stops without warning for any reason, do the following:
1. Switch o (O) and unplug the appliance.
2. Allow the appliance to cool down for 15 min
3. Once cooled down the protection device will automatically reset and the
appliance can be used normally again.
CARE AND MAINTENANCE
Switch o (O) and unplug before cleaning.
1. Turn the jug anti-clockwise to unlock, and lift it o the motor unit.
2. Handwash the jug, lid and cap.
3. Use a brush to clean the blades.
Loading ...
Loading ...
Loading ...