User Manual - Page 12

For KSV25HWH. Also, The document are for others Kelvinator models: KSV25HRH, KSV35HRH, KSV50HRH, KSV71HRH, KSV90HRH, KSD25HRH, KSD35HRH, KSD50HRH, KSD71HRH, KSD90HRH, KSV35HWH, KSV50HWH, KSV71HWH, KSV90HWH, KSD25HWH, KSD35HWH, KSD50HWH, KSD71HWH, KSD90HWH

Loading ...
Loading ...
Loading ...
12 Timer operation
Timer operation
Press the Timer button can set the auto-on/off time of the unit.
Mode ON/OFF
Fan
Quiet
1
remiT remiT
Follow
me
Self
clean
Short
cut
LED
Swing
Direct
Turbo
To set the Auto-ON time
1. Press the Timer button till the remote controller shows Timer On
indicator “ ”, the last Auto-on setting time and the signal "h"
will be shown on the LCD display area. Now it is ready to reset
the Auto-on time to START the operation.
2. Push the UP and Down button to set desired Auto-on time.
Each time you press the button, the time increases by half an
hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. After setting the Timer On ,there will be a one second delay
before the remote controller transmits the signal to the air
conditioner. Then, after approximately another 2 seconds,
the signal "h" will disappear and the set temperature will
re-appear on the LCD display w
indow.
WARNING
caution
When you select the timer operation, the remote controller
automatically transmits the timer signal to the indoor unit for
the specied time. Therefore, keep the remote controller in
a location where it can transmit the signal to the indoor unit
properly.
Timer setting is in half hourly intervals up to 10 hours then
hourly intervals to 24 hours.
Sleep
To set the Auto-OFF time
1. Press the Timer button till the remote controller shows Timer Off
indicator “ ”, the last Auto-off setting time and the signal "h"
will be shown on the LCD display area. Now it is ready to reset
the Auto-off time to STOP the operation.
2. Push the UP and Down button to set desired Auto-off time.
Each time you press the button, the time increases by half an
hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. After setting the Timer Off ,there will be a one second delay
before the remote controller transmits the signal to the air
conditioner. Then, after approximately another 2 seconds,
the signal "h" will disappear and the set temperature will
re-appear on the LCD display wind
ow.
Loading ...
Loading ...
Loading ...