Loading ...
Loading ...
Loading ...
7
COFFEE DISPENSER ASSEMBLY
Be sure you have a thorough familiarity with the
assembly and installation process before turning
on your coffee dispenser.
NOTE: Once casters are assembled, place your
unit in an upright position and allow it to sit for
at least 8-10 hours before plugging into an
outlet. This will allow the refrigerant to settle
before operation.
Caster Assembly
1. Remove every-
thing from the
cabinet and lay
the unit on a
clean, dry and
padded surface.
2. Install casters
into holes on
bottom of unit
as shown and
tighten with a wrench. Two of the four casters
provided are equipped with locks to prevent
slippage of the keg on smooth surfaces such
as hardwood floors, linoleum or tile. These
casters should be installed on the front of
the unit.
3. Once all four casters are attached, return the
coffee dispenser to an upright position and
allow it to rest for at least 8-10 hours. (See
Note above.)
Guardrail Installation
To install the guardrail,
1. Place the guardrail on top of the coffee
dispenser and line up the feet of the guardrail
with the holes on top of the cabinet.
2. Using the screws provided, secure each foot to
the cabinet.
Coffee Tap Installation
1. Put draft tower directly over the hole on the
top of the coffee dispenser’s upper
surface. Fix the tower assembly with screws
directly to the upper surface of the
dispenser. (See figures A and B in the next
column.)
While not required, we recommend the use of
the black rubber gasket when installing the
coffee tap. Using the gasket will provide a
more secure seating for the arm assembly.
Coffee Dispenser
Tower
Coffee Duct
Figure B
Loading ...
Loading ...
Loading ...