Loading ...
Loading ...
Loading ...
EN8
CONTROLS
Light :
move the switch to the right or press the button to switch on.
Extraction speed :
Move the switch to the right or press the next button to increase extraction speed (or open the electric shutter )
MAINTENANCE
GREASE FILTERS
Traps cooking grease particles.
The grease lter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease lter may discolour slightly, but this does not aect its ltering capacity.
To remove the grease lter, pull the spring release handle. Fig. 1.
Charcoal lter (lter version only) (Fig. 2)
It absorbs unpleasant odours caused by cooking.
The saturation of the activated charcoal occurs after more or less prolonged use, depending on the type of cooking and
the regularity of cleaning of the grease lter.
In any case it is necessary to replace the cartridge at least every four mounths.
The carbon lter may NOT be washed or regenerated.
Remove the grease lters.
Fit the charcoallters over the motor.
Align the pins R on the cowl with the slots S, then turn the lter clockwise until it locks in place.
Reverse the above procedure to remove the charcoal lters.
Ret the grease lters.
Replacing lamps (Fig. 1)
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled down.
Remove cover A to access the lamp housing A.
If the lights do not work, make sure that the lamps are tted properly into their housings before you call for technical
assistance.
Lamp Power(W) Socket Voltage(V) Dimension
(mm)
ILCOS D Code
(according IEC
61231)
28 E14 230 67
(Light
Center
Length)
HSGSB/C/UB-28-
230-E14-67
Loading ...
Loading ...
Loading ...