Loading ...
Loading ...
Loading ...
EN9
INSTALLATION – ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the gures (with the same step numbers) given on the last pages of this
manual.
IMPORTANT: the product in your possession may have an aesthetic slightly dierent than shown in this manual, however, the instructions for
installation remain the same.
The carbon lter is NOT supplied and must be purchased separately
1. Mark a vertical centre line on the wall.
2. Place the drilling diagram against the wall (x it with adhesive tape): the vertical centre line printed on the drilling diagram must match the centre line drawn
on the wall.
Note: the bottom edge of the drilling diagram corresponds to the bottom edge of the hood.
IMPORTANT: The bottom edge of the drilling diagram must have a min. distance of 55 cm (for electric hobs) or 70 cm (for gas hobs).
3. Drill the 4 holes as shown on the drawing.
4. Remove the drilling diagram from the wall, insert the 2 plugs and the 2 screws in the wall, making sure they protrude about 5 mm; insert the third and fourth
plug in the bottom holes.
5. Only for ducting version: apply the chimney support bracket to the wall against the ceiling. Drill and insert wall plugs as shown. Fix the bracket.
6. Only for ducting version - rear discharge: make a hole on the rear wall for the passage of the exhaust pipe.
7. Only for ducting version - exhaust at the ceiling: Drill a hole in the ceiling for the passage of the exhaust pipe.
8. Prepare the connection to the domestic power supply..
9. Twist the front panel upwards.
10. Remove the grease lter.
11. Only Recirculating version: Install the carbon lters on the motor as shown on the picture. Turning the lters to lock them to the central pins.
12. Hook the hood to the xing screws through the appropriate back holes.
Insert washers and screws in the lower safety holes.
Fix the hood to the wall by acting further on the two xing screws.
13a. 13a.Only Ducting version: Connect the hose to the exhaust fumes, to the air outlet hole of the hood.
13b. 13b.Only for Recirculating version: Install, on the air outlet hole of the hood, the plastic grid.
14. For Extractor Version only: t the fume non-return valve to the upper motor outlet. The pipe must be routed to the outside (rear discharge or towards the
ceiling).
15. Only for Ducting version: Insert the chimney on the specic place above the hood to cover the exhaust gas pipe. Fix the top chimney, through 2 screws, to the
mounting bracket.
Check hood operation, referring to the section giving a description of the hood and its use..
Loading ...
Loading ...
Loading ...