Loading ...
Loading ...
Loading ...
17
1. Remove the drip tray and the grounds container (A10) (g.
27);
2. Empty the drip tray and grounds container and wash them;
3. Check the condensate tray (A9) and empty if necessary;
4. Replace the drip tray and grounds container.
11.5 Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see section “6. TURNING THE APPLIANCE OFF”) and unplugged
from the mains power supply. Never immerse the coee ma-
chine in water.
1. Check regularly (about once a month) that the inside of the
appliance, accessible after removing the drip tray (A12)
(g. 27), is not dirty. If necessary, remove coee deposits
with the brush (C5) supplied and a sponge.
2. Remove all the residues with a vacuum cleaner (g. 30).
11.6 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener lter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the lter (if present) and rinse with running water;
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank;
4. (Models with water softener lter only) Deliver about 3,38
.oz/100 ml of hot water to reactivate the lter.
11.7 Cleaning the coee spouts
1. Clean the coee spouts (A7) regularly with a sponge or
cloth (g. 31);
2. Check that the holes in the coee spouts are not blocked.
If necessary, remove coee deposits with a toothpick (g.
31).
11.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground
coee funnel (A4) is not blocked. If necessary, remove coee
deposits with the brush (C5) supplied.
11.9 Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
“6. TURNING THE APPLIANCE OFF”);
2. Remove the water tank (A16-g. 3);
3. Open the infuser door (A14) (g. 32) on the right side of
the appliance;
33
PUSH
4. Press the two coloured re-
lease buttons inwards and
at the same time pull the
infuser outwards (g. 33);
5. Soak the infuser in water for
about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID
NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 34), then push the PUSH symbol fully
in until it clicks into place;
34
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 35.
35
8. Once inserted, make sure the two coloured buttons have
snapped out (g. 36);
36
PUSH
9. Close the infuser door;
10. Put the water tank back.
Infuser
support
Loading ...
Loading ...
Loading ...