Loading ...
Loading ...
Loading ...
E2 E3
1 HOW TO MOUNT
1-2 Mounting the
Accessories for Full-
servo Operation
The servo demand is mounted and connected as shown in
the gure below. When mounting the various demands, refer
to the operation manual for the respective demand.
① Servo module
② Zoom servo demand
③ Focus servo demand
④ Demand cable
Mounting the Servo Module onto the
Lens
It is necessary to mount the servo module to the zoom and
focus couplings located in the bottom compartment of the
lens.
* (NOTE)
The same servo module is used for both zoom and focus couplings.
So, it can be mounted on either the zoom or focus coupling.
1
Before mounting a module to the lens, turn the lock
screw of the module counterclockwise until the lock
axis comes out to its a half way of length.
2
Press the module in the direction of arrow “A”, so
that the key pins on the lens are inserted in the key
grooves of the module.
Coupling B
Index Line
(White Line)
Arrow A
Key
Groove
Bottom compartment of the lens
Lock Axis
Lock Screw
Servo Module
Coupling A
Key Pin
3
Mate the coupling A of the module with the coupling
B of the lens. And then, fully push the module in the
direction of arrow “B” until it stops.
4
Finally, turn the lock screw of the module clockwise to
secure it. By using a coin, tighten rmly the lock knob.
Arrow B
Lock Screw
Lock
Next, as the same procedure, install the servo module on
the other joint. It does not matter which is installed rst,
either the zoom or the focus.
* (NOTE)
When mating couplings A and B, push the servo module in
completely, so that the index line (white line) on the circumference
of coupling B is entirely hidden. If index line is not completely
hidden, the servo module may fail to operate, or it may generate
abnormal acoustic noise.
Loading ...
Loading ...
Loading ...