Loading ...
Loading ...
Loading ...
Option 2, No waste disposer - with air gap:
1. Cut end of drain hose if needed (do not cut ribbed
section).
2. Attach drain hose to air gap with [arge spring-type
champ, if the drain hose was cut, use a 1-1/2" to 2"
(&8 to 5 cm) screw-type cHamp x,
3. Use a rubber hose connector _ with spring or screw-
type damps .×.to connect air gap to waste tee_
This connection must be before the drain trap and at
[east 20" (50.8 cm) above the floor where dishwasher
wH[ be instaiied_
drain hose-
cut here if needed
rubber hose
connector
large
spring4ype
waste
tee drain
drain trap hose
J
4. insert drain hose | drain hose
through hob cut in
cabinet to the front
center of opening where
drain connection will be / .....................
made.
Parts available from local plumbing supply stores
Option 3, Waste disposer - no air gap:
1. Remove the disposer knockout piug. Do not cut end of
drain hose.
2. Attach drain hose to disposer inlet with large spring-
type damp.
This connection must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed, it is recommended that the drain hose
be looped up and securely fastened to the underside of
the counter.
large spring-type
clamp
drain hose
disposer
inlet
drain trap
/
3. insert drain hose |
through hole cut in
cabinet to the front
center of opening where
drain connection will be
made.
drain hose
Option 4, No waste disposer - no air gap:
1_ Cut end of drain hose if needed (do not cut ribbed
section).
2. Attach drain hose to waste tee with lq/2" to 2"
(3.8 to 5 cm) screw-type ciampX.
This connection must be before the drain trap and at
bast 20" (50.8 cm) above the floor where dishwasher
wiil be installed, it is recommended that the drain hose
be looped up and securely fastened to the underside of
the counter.
3. insert drain hose
through hole cut in
cabinet to the front
center of opening where
drain connection will be
made.
drain hose
Parts available from local plumbing supply stores
Prepare cabinet opening where there
are no existing utility hookups
Electrical connection
Option1, Direct wire method:
HeJpfu_Tip: Wiring the dishwasher wiii be easier if you
route wire into the cabinet opening from the right side.
1. Drill a 3/4" (1.9 cm) optional preferred
hob in right-hand locations locations
cabinet side, rear or
floor. Preferred and
optional locations are
shown.
2. Wood cabinet: Sand
hob until smooth.
3,
4.
5,
Metal cabinet: Cover
hob with grommet, not provided.
Run wire into house wiring junction box.
Install a U.Lqisted/CSA-certified clamp connector
(strain relief) for flexible-type wire. If installing conduit,
attach a U.L.qisted/CSA-certified conduit connector to
the junction box.
Run other end of wire
through cabinet hole.
Cable must extend to the
right front of cabinet
opening.
Loading ...
Loading ...
Loading ...