Loading ...
Loading ...
Loading ...
Complete installation
1. Check that grounding chip is attached to the Hower
panel
2. Hace the lower paneH behind the access panel Some
modeHs have insuhfion on the access paneH which must
fall behind the insuhfion on the lower panel
grounding
clip
3. Hold the two panels together and prince them against
dishwasher Hog,
4. Reinstall the screws through the holies in the access
paneH and the shots in the lower panel hstaH right side
screw first,
J
J
J
5. Check that the lower edge of the lower panel contacts
the floor,
6. Tighten the screws,
Direct wire method:
Emectricat Shock Hazard
EmectricaHy ground dishwasher.
Connect ground wire to green ground connector in
terminam box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or emectricam shock.
Power supply cord method:
Emectrical Shock Hazard
Plug into a grounded 3 prong outmeto
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Faimure to follow these instructions can result in death,
fire, or emectrica_ shock.
7. Reconnect power or plug in dishwasher.
Check operation
1,
2.
3.
4.
5,
6,
Read the Use and Care Guide that came with your
dishwasher,
Check that all parts have been installed and no steps
were skipped,
Check that you have all the tools you used,
Start dishwasher and allow it to complete the shortest
wash cycle, After the first two minutes, unlatch door,
wait five seconds, then open door,
Check to see that there is water in the bottom of the
dishwasher tub, Check that dishwasher is working
properly,
If not, disconnect power or unplug dishwasher and see
"If dishwasher does not operate" section,
14
Loading ...
Loading ...
Loading ...