Loading ...
Loading ...
Loading ...
Connect to drain
1. To heHp minimize
vibration, route drain
hose to avoid contact
with motor, door springs,
water Hine, cabinet,
flooring or the edge of
the hoHe where it passes
through the cabinet.
2. Do not remove drain
Hoop from side of
dishwasher_
3. Hace pan under end of drain hose. Pan wHHcollect any
water in drain hose.
4. Remove pHug and paper from drain connector.
NOTE: Cutting the zip tie hoHding the end of drain hose
in pHace may make maneuvering the drain hose easier
during installation.
zip tie
5. Hace the smaller drain hose
champ onto the small end of the
drain hose.
hose
/J clamp
6. Push the drain hose into the connector up to the stop
on the drain hose.
connector stop
7. Use pliers to open clamp and slide clamp onto
connector between stops on connector as shown.
hose clamp
,j
stops
Secure dishwasher in cabinet opening
Tip Over Hazard
Do not use dishwasher antimcompletely installed.
Do not push down on open door.
Doing so can result in serious iniury or cuts.
1. If you have not already done so, open dishwasher door
and place towel over pump assembly and spray arm of
dishwasher.This will prevent screws from falling into
pump area when securing dishwasher to countertop.
2. Check that dishwasher is still level and centered side to
side in the opening.
3. Secure dishwasher to countertop with two, #10 x 1/2"
Phillips-head screws. The dishwasher must be secured
to keep it from tipping when door is opened. Do not
drop screws into bottom of dishwasher.
4. Open door about 3 inches (7.6 cm) and check that space
between inner door and tub is equal on both sides. If
spacing is not equal, loosen bracket screws and shift
tub.Tighten bracket screws.
5. Check that top of door does not contact screws,
brackets, or countertop. If it does, dishwasher must be
lowered and reoleveled.
6. Remove towel from dishwasher.
7. Reinstall the lower dishrack
13
Loading ...
Loading ...
Loading ...