Loading ...
Loading ...
Loading ...
262 STARTING AND OPERATING
Enabling And Disabling ParkSense
ParkSense can be enabled and
disabled with the ParkSense switch,
located on the switch panel below the
Uconnect display.
When the ParkSense switch is pushed to disable
the system, the instrument cluster will display the
“PARKSENSE OFF” message for approximately five
seconds. Refer to “Instrument Cluster Display” in
“Getting To Know Your Instrument Panel” for
further information. When the gear selector is
moved to REVERSE and the system is disabled, the
instrument cluster display will show the
“PARKSENSE OFF” message for as long as the
vehicle is in REVERSE.
The ParkSense switch LED will be on when Park-
Sense is disabled or requires service. The Park-
Sense switch LED will be off when the system is
enabled. If the ParkSense switch is pushed, and
requires service, the ParkSense switch LED will
blink momentarily, and then the LED will be on.
NOTE:
When KeySense feature is present, the Park-
Sense System will reject customer input to turn
the system off via the hard switch. The instru-
ment cluster display will show "KeySense in Use
Selected Feature Cannot be Disabled"
message.
Service The ParkSense Park Assist System
During vehicle start up, when the ParkSense
System has detected a faulted condition, the
instrument cluster will actuate a single chime,
once per ignition cycle, and it will display the
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS", "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS", or the "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
for five seconds. When the gear selector is
moved to REVERSE and the system has
detected a faulted condition, the instrument
cluster display will show a "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS", "PARK-
SENSE UNAVAILABLE WIPE FRONT SENSORS"
or "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" pop up message for five seconds.
After five seconds, a vehicle graphic will be
displayed with a "WIPE OFF" or “SERVICE”
overlay, depending on the location and fault
type. The system will continue to provide arc
alerts for the side that is functioning properly.
These arc alerts will interrupt the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS", "PARK-
SENSE UNAVAILABLE WIPE FRONT SENSORS",
or "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" messages if an object is detected
within the five second pop-up duration. The
vehicle graphic will remain displayed for as long
as the vehicle is in REVERSE.
Refer to “Instrument Cluster Display” in
“Getting To Know Your Instrument Panel” for
further information.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or "PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS" appears in the instrument
cluster display make sure the outer surface and
the underside of the rear fascia/bumper and/or
front fascia/bumper is clean and clear of snow,
ice, mud, dirt or other obstruction and then
cycle the ignition. If the message continues to
appear see an authorized dealer.
If the "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message appears in the instrument
cluster display, see an authorized dealer.
Cleaning The ParkSense System
Clean the ParkSense sensors with water, car
wash soap and a soft cloth. Do not use rough or
hard cloths. Do not scratch or poke the sensors.
Otherwise, you could damage the sensors.
20_RU_OM_EN_USC_t.book Page 262
Loading ...
Loading ...
Loading ...