Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 109
2. Return to vacuum nozzle storage location
located behind the sliding door.
3. Grab the vacuum nozzle and gently pull the
hose out through vacuum nozzle storage
location.
4. Shake the hose to remove any objects stuck
in the hose. Take care not to perforate the
hose while attempting to dislodge any
objects.
5. Reverse the procedure to reinstall and clip
the hose into place.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink® replaces up to three hand-held
transmitters that operate devices such as
garage door openers, motorized gates, lighting
or home security systems. The HomeLink® unit
is powered by your vehicle’s 12 Volt battery.
The HomeLink® buttons, located on the driver’s
sunvisor, designate the three different Home-
Link® channels. The HomeLink® indicator is
located above the center button.
HomeLink® Buttons/Overhead Console
NOTE:
HomeLink® is disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink®
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accurate
transmission of the radio-frequency signal it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink® system.
To erase the channels, place the ignition in the
ON/RUN position, and push and hold the two
outside HomeLink® buttons (I and III) for up to
20 seconds or until the orange indicator
flashes.
NOTE:
Erasing all channels should only be
performed when programming HomeLink®
for the first time. Do not erase channels when
programming additional buttons.
If you have any problems, or require
assistance, please call toll-free
1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
2
20_RU_OM_EN_USC_t.book Page 109
Loading ...
Loading ...
Loading ...