Loading ...
Loading ...
Loading ...
30_ troubleshooting and information codes
troubleshooting and
information codes
INFORMATION CODES
Information codes may be displayed to help you better understand what is occurring with your washer.
CODE SYMBOL MEANING SOLUTION
dc
Unbalanced load prevented your
washer from spinning.
Redistribute the load, press the Start/Pause
button.
dL
Door is unlocked when washer is
running.
Press the Power button to turn off your washer,
then restart the cycle. If the code reappears, call
for service.
dS
Door is open when washer is
running.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
FL
Your washer failed to lock the
door.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Hr
Water temperature control
problem.
(Heater control problem)
Call for service.
LE
Your washer has tried to fi ll but
has not reached the proper water
level.
Call for service.
LO
The door will not unlock. Make sure the door is fi rmly closed.
Press the Power button to turn off your washer,
then turn it on again. If the code reappears, call
for service.
nd
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
First of all, clean up the drain fi lter. then check
the following. Clean the fi lter (See page 26).
or
1. Turn off the unit for 10 seconds and then turn
it on again.
2. Select the Spin Only cycle.
3. Press the Start/Pause to drain the water.
If it still does not drain, call for service.
nF
Your washer has tried to fi ll but
was unsuccessful.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fi ll hoses.
if you use a Flood Safety Device, then please
remove the device and connect the water hoses
directly to the unit.
nF1
The hot/cold water hose
connection is not correct.
Please connect the hot/cold water hose
connection correctly.
Sr
Problem with control. Call for service.
OE
A fault is detected in the water
level sensor.
Call for service
E2
Jammed key. Call for service
tE
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
WF409ANW-02657D-04_EN.indd Sec7:30WF409ANW-02657D-04_EN.indd Sec7:30 2011-04-25 11:44:332011-04-25 11:44:33
Loading ...
Loading ...
Loading ...