Loading ...
Loading ...
Loading ...
EN
19
6. Troubleshooting
NO.
Malfunction Possible Causes Solutions
3
Status Indicator
Light of the product
Interruption of electricity while
WINBOT 8 was cleaning due to
power failure, plug displacement,
or loose connection to the Power
Adapter.
A. Connect WINBOT 8 to the Power
Adapter and plug into the wall
receptacle. Press Start/Pause Button on
WINBOT 8 or on the Remote Control.
WINBOT 8 will resume cleaning.
B. In case of power failure, and the
above solution does not work, please
use the Direction Control Buttons on
the Remote Control to direct WINBOT 8
to a position on the window where you
can safely reach it, turn off the fan and
remove it from the window. If power
has resumed, place WINBOT 8 on the
window again and restart.
WINBOT 8 has moved over a
problem area and is losing suction.
A. Press the RESET Button on the
Remote Control. Use the Direction
Control buttons on the Remote
Control to move WINBOT 8 away
from the problem area and at least
10cm/4” from window corners and
obstacles. Restart WINBOT 8.
B. Press the RESET Button on
the Remote Control, then use the
Direction Control Buttons to direct
WINBOT 8 to clean around the
problem area.
Edge Detection Sensors are dirty
Wipe the four Edge Detection Sensors
clean as described in section 4. If
the problem persists, please contact
Customer Service.
4
WINBOT 8 moves in
an irregular pattern
during cleaning.
There is too much dirt and debris
on the window.
A. Spray additional Cleaning Solution
on the upper and lower sides of the
Cleaning Pad.
B. Clean the Driving Treads as
described in section 4.
C. Replace the Cleaning Pad and
restart the cleaning cycle.
D. Clean the window using the
Direction Control Buttons on the
Remote Control.
use WINBOT 8 for regular cleaning
after that.
*
WINBOT 8 is intended to be used
for maintenance cleaning on common
windows. The product is NOT
time cleaning.
Loading ...
Loading ...
Loading ...