Loading ...
Loading ...
Energy Saving Ideas
o The capacity of the room air conditioner must fit the room sizefor efficient and
satisfactory operation
• Install the room air conditioner on the shady side of your home A window that
faces north is best because it isshaded most of the day
° Do not block air flow inside with blinds, curtains or furniture; or outside with
shrubs, enclosures, or other buildings
o Close the fireplace damper, floor and wall registers so cool air does not escape
up the chimney and into the duct work,
, Keep blindsand drapesin other windows closedduring the sunniest partof the day
• Clean the air filter as recommended in the section "Care and Cleaning,"
o Proper insulation andweather stripping in your home will help keep warm air out
and cool air in
o External house shading with trees, plants or awnings will help reduce the air
conditioner's work load
° Operate heat producing appliances such as ranges, washers, dryers and
dishwashers during the coolest part of the day
Front Installation
Bottom Rail
Seal
T
InstallingWindow Seal
Vertical
Screw
J.
Unit Cover
Horizontal
Louvers Front Panel
Front installation - Side Air Discharge
(some models)
Installing Bottom Rail Seal (some models)
Some models are shipped in a removable sleevethat must be positioned correctly
for safe and efficient sealing Follow the Installation Instructions supplied with the
model,
Manual Vertical Louver Adjustment (side air discharge)
Complete this adjustment before installing front panel,
1 Adjust the vertical louvers to the straight position by using the handle
2 The dial plate and knobs are packed separately To install them, refer to
Installing the Dial Plate and Front Frame Section following,
Front Installation (some side air discharge models)
Install the front panel with filter asfollows
1 Adjust the horizontal louvers to the straight position Hold the front straight until
the vertical louver handle linesup between the bottom horizontal louver and the
discharge opening
2, Pressthe front straight onto the cabinet until the holes in the flange of the plastic
front line up with the screw holesin the metal cabinet Fastenthe front panel in
place with the two screws provided
installing the Vent Control (some models)
The vent control handle is included in the decorative front kit, To install the vent
handle, refer to illustrations below The handle must be attached before the
decorative front isattached Insert the handle with the tab facing the right
Snapthe slot of the clear actuator strip over the handle tab, PRESSthe strip inplace
from the back of the tab, asshown below, until the tab "clicks" into position, Move
the handle in and out to be surevent operation isworking Ifnot, repeat vent handle
procedure until the vent functions properly
Loading ...
Loading ...
Loading ...