Loading ...
Loading ...
Loading ...
Fault, what to do? en
45
Fault table
Fault Cause Remedial action
Error code “:‚‰ is lit. Supply hose kinked. Install supply hose without kinks.
Tap turned off. Turn on the tap.
Tap jammed or calcified. Turn on the tap.
Flow rate must be min. 10 l/min. when
water supply is open.
Filter in the water supply blocked. Switch off the appliance and pull out the
mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Error code “:‹ˆ is lit. Intake opening (on right inside of
appliance) covered by utensils.
Arrange utensils so that the intake
opening is not obstructed.
Error code “:‚ƒ is lit. Heating element calcified or
soiled.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting. ~ " Water softening
system/special salt" on page 19
Fault code “:‚… is lit. Water protection system
activated.
Turn off tap.
Call customer service and mention the
fault code.
Fault code “:‚† is lit.
Fault code “:‚‡ is lit. Constant water inflow.
Error code “:ƒƒ is lit. Filters 1j are soiled or
blocked.
Clean filters. ~ "Filters" on page 42
Error code “:ƒ… is lit. Waste-water hose kinked or
blocked.
Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Cover on the waste water pump
loose.
Lock cover correctly. ~ "Waste water
pump" on page 44
Loading ...
Loading ...
Loading ...