Loading ...
Loading ...
Loading ...
50 English
Troubleshooting
Troubleshooting
Problem Action
Fills with the wrong
water temperature.
Fully open both taps.
Make sure the temperature selection is correct.
Make sure the hoses are connected to the correct taps. Flush
water lines.
Make sure the water heater is set to supply a minimum
120 °F (49 °C) hot water at the tap. Also, check the water
heater capacity and recovery rate.
Disconnect the hoses and clean the mesh lter. The mesh lter
may be clogged.
While the washing machine lls, the water temperature may
change as the automatic temperature control feature checks
incoming water temperature. This is normal.
While the washing machine lls, you may notice just hot and/
or just cold water going through the dispenser when cold or
warm temperatures are selected.
This is a normal function of the automatic temperature
control feature as the washing machine determines the water
temperature.
Load is wet at the
end of a cycle.
Use the High or Extra High spin speed.
Use high efciency (HE) detergent to reduce oversudsing.
Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
Make sure the drain hose is not kinked or clogged.
Leaks water.
Make sure the door is properly closed.
Make sure all hose connections are tight.
Make sure the end of the drain hose is correctly inserted and
secured to the drain system.
Avoid overloading.
Use high efciency (HE) detergent to prevent oversudsing.
Has odours.
Excessive suds collect in recesses and can cause foul odours.
Run cleansing cycles to sanitize periodically.
Clean the door seal (diaphragm).
Dry the washing machine interior after a cycle has nished.
No bubbles are seen
(Bubbleshot models
only).
Overloading may screen bubbles.
Severely contaminated laundry may not generate bubbles.
WD80J5A10AW(AX)_03666E-01_EN.indd 50 2018/3/7 14:09:58
Loading ...
Loading ...
Loading ...