User Manual - Page 10

For ECI341W. Also, The document are for others Delonghi models: ECI341

Loading ...
Loading ...
Loading ...
10
3. Remove the rubber steam connection nozzle from the
spout by pulling it downwards (g.21).
4. Wash the cappuccino maker and steam connection nozzle
thoroughly with warm water (g. 22).
5. Clean the steam spout, taking care to avoid burns.
6. Replace the cappuccino maker by pushing upwards and
turning anticlockwise.
HOT WATER
1. Turn the appliance on by pressing the ON/OFF button (g.
4). Wait the OK indicator light comes on.
2. Place a recipient under the cappuccino maker.
3. When the OK indicator light comes on, turn the selector
dial to the
position and at the same time, rotate the
steam dial anticlockwise. Hot water is delivered from the
cappuccino maker.
4. To interrupt delivery of hot water, rotate the steam dial
clockwise and position the selector dial to
.
You should not deliver hot water for more
than 60 seconds.
CLEANING
Danger! Before cleaning the outside of the appliance,
turn it o, unplug from the mains socket and allow to cool.
Cleaning the drip tray
Important!
The drip tray is tted with a level indicator (red) showing the
level of water it contains (g. 23). Before the indicator protrudes
from the cup tray, the drip tray must be emptied and cleaned,
otherwise the water may overow the edge and damage the
appliance, the surface it rests on or the surrounding area.
1. Remove the drip tray.
2. Remove the cup tray, empty the water and clean the drip
tray with a cloth, then reassemble the drip tray.
3. Put the drip tray back in place.
Cleaning and maintenance of the lters
About every 200 coees or when the coee is delivered a drop
at a time of the lter holder or not at all, clean the pre-ground
coee lter holder and the lters as follows:
Remove the lter from the lter holder.
Rinse and clean the metal lter thoroughly in hot water
using a brush. Make sure the holes in the metal lter are
not blocked. If necessary, clean with a pin (see g. 24).
Failure to clean as described above invalidates the guarantee.
Cleaning the boiler outlet
About every 300 coees, the boiler outlet must be cleaned as
follows:
Make sure the appliance is not hot and that it is unplugged
from the mains;
Using a screwdriver, unscrew the screw xing the espresso
boiler outlet (g. 25);
Remove the boiler outlet;
Clean the boiler with a damp cloth (g. 25);
Clean the outlet thoroughly in hot water using a brush.
Make sure the holes are not blocked. If necessary, clean
with a pin.
Rinse under running water, rubbing all the time.
Replace the boiler outlet, making sure the gasket is cor-
rectly positioned.
Failure to clean as described above invalidates the guarantee.
Other cleaning operations
1. Do not use solvents or abrasive detergents to clean the cof-
fee machine. Use a soft damp cloth only.
2. Clean the lter holder cup, lters, drip tray and water tank
regularly. To empty the drip tray, remove the cup tray grille,
remove the water and clean the tray with a cloth: then re-
assemble the drip tray. Clean the water tank, using a soft
brush to reach the bottom.
Danger! While cleaning, never immerse the coee
maker in water. It is an electrical appliance.
DESCALING
You are recommended to descale the coee maker about every
200 coees. You should use commercially available De’Longhi
descaler. Proceed as follows:
1. Fill the tank with the descaler solution obtained by diluting
the descaler with water following the instructions on the
pack.
2. Press the ON/OFF button.
3. Make sure the lter holder is not attached and position a
recipient under the cappuccino maker.
4. Wait until the OK light comes on.
5. Turn the selector to the
position and deliver about
1/4 of the solution in the tank: from time to time open the
steam dial to discharge steam. Then interrupt delivery by
turning the selector to the
position and leave the
solution to work for about 5 minutes.
6. Repeat point 5 another 3 times, until the tank is empty.
7. To eliminate residues of descaler solution, rinse the tank
well and ll it with clean water (without descaler).
8. Turn the selector to the
position and deliver water
until the tank is empty.
9. Repeat points 7 and 8.
Loading ...
Loading ...