Loading ...
Loading ...
Loading ...
Platinum by Tunturi 6 4 in 1 Strength Station Owner's Manual
www.tunturi.com 7 4 in 1 Strength Station Owner’s Manual
Platinum by Tunturi 18 4 in 1 Strength Station Owner's Manual
Step 25:
IMPORTANT - Check These Components Before Using Gym:
Final Assembly and Troubleshooting
• Wrench Tighten the set screws on all Threaded Collars using an
allen wrench, so that the set screws tighten against the shaft. Refer
to Step 1.
Threaded Collar
• Each Free Floater must be threaded at least 1/2”
into the Top Plate of the weight stack. Each must
also be secured with a 1/2” Jam Nut to ensure a
safe and proper connection.
• Verify that all cables lie in between the guide bolts,
tubes and the pulleys. Routing the cables over the
guide bolts causes premature cable wear and will
void your warranty.
Make Sure Cable is not pinched in between
the tube and the pulley support plate.
Guide Bolts
www.tunturi.com 19 4 in 1 Strength Station Owner’s Manual
Platinum by Tunturi strives to give you the very best in quality, performance and safety through carefully engineered designs and
excellent workmanship. In order to maintain this high level of quality the preventative maintenance schedule below should be
followed.
Clean upholstery, grips, and roller pads with mild soap and water generally after every use. The guide rods, chrome slides and frame
should be cleaned with a cotton cloth. Upon cleaning the guide rods, a thin layer of Silicone or Teflon gel should be applied to each
rod to ensure a glass smooth performance.
An overall inspection should be done before each workout. If the warning and safety decals are worn or have been removed they
should be replaced immediately. The cables and cable systems should be inspected for signs of wear and proper tension. In order to
check cables properly you should carefully run the cable through your fingertips, checking for signs of wear, cracks, burs and thinning
spots. Replace any part at first signs of wear. Cables should be adjusted for proper tension. See assembly instructions for this
detail. All hardware, stops, and adjustments should be checked and tightened as required.
The guide rods on your machine should be cleaned and lubricated regularly. This will ensure a glass smooth performance from your
weight stack. A thin layer of either Silicone or Teflon gel should applied to each rod. Each pillow block bearing and flange bearing
has a grease fittings that must be lubricated regularly. Use general purpose bearing grease and follow the schedule below.
Although cables should be inspected daily, it is important that ALL cables be replaced as directed in the schedule below. Please note
that at any first sign of wear the cable should be replaced immediately.
If there are any questions concerning maintenance, please contact your local Tunturi dealer or contact Platinum by Tunturi directly at:
www.tunturi.com
Daily Weekly Monthly Quarterly Years
Clean
Upholstery X
Hand Grips X
Roller Pads X
Guide Rods X
Chrome Slides X
Frame X
Inspect
Overall X
Safety Decals X
Cables X
Cable Tension X
Pulleys X
Hardware X
Stops X
Upholstery X
Hand Grips X
Frame X
Bushings X
Bearings X
Lubricate
Guide Rods X
Bearings 1
Replace
Cables 3
Preventive Maintenance
PG6251說明書101025---001 拚版用-12.indd 13-14 2010/11/3 20:38:24
Loading ...
Loading ...
Loading ...