Loading ...
Loading ...
Loading ...
Cleaning and maintenance
143
EN
Removing and installing the door seal
(not on pyrolytic models)
To remove the seal:
• Release the clips located in the 4 corners
and pull the seal outwards.
To refit the seal:
• Hook the clips in the 4 corners onto the
seal.
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-
abrasive sponge and wash with
lukewarm water.
What to do if...
The display is completely off:
• Check the mains power supply.
• Check that any circuit breakers upline of
the appliance supply line are in the
“ON” position.
The appliance does not heat up:
• Check whether "Showroom (for
showrooms only)" or "Demo Mode (for
showrooms only)" mode has been set
(for further details see section "Settings").
The controls do not respond:
• Check whether "Controls lock" mode
has been set (for further details see
section "Settings").
After the (pyrolytic) automatic cleaning
cycle it is not possible to select a function:
• Verify whether the door lock has
deactivated. If it has not, the oven has a
safety device that does not allow
functions to be selected while the door
lock is active. This is because the
temperature inside the oven is still too
high to permit any type of cooking.
Loading ...
Loading ...
Loading ...