Loading ...
Loading ...
Loading ...
5. Remove set screws securing belt to belt clamp using a 7/32" Allen wrench.
QtyDescription
1Belt clamp1
2Set screw2
Remove weight plates
1. Turn the increment weight adjusting knob to select 0 lbs (0 kg).
2. Remove top guide rod caps. Top guide rod cap contains a compression spring that will fly if grasp is not
released slowly. Slide spring loaded top guide rod cap down guide rod until cap is clear of frame. Slowly release
grasp of top guide rod cap and set aside.
QtyDescription
2Top guide rod cap1
2Guide rod2
1Guide rod plate3
3. Repeat above step for opposite guide rod.
4. Lean guide rods slightly outward, away from machine. DO NOT put excessive pressure on guide rods, it will
damage lower guide rod caps.
5. Slide top weight up and out of the machine and set aside.
6. Remove weight plates and set aside for re-installation later.
7. Move to desired location.
Install chin handle
1. Carefully remove hardware kit, chin handle and support leg secured to frame.
Page 12 of 26
Loading ...
Loading ...
Loading ...