Loading ...
Loading ...
Loading ...
Installation and connection en
9
Saving energy with the hob
■ Use pots and pans with thick, even bases. Uneven
bases increase energy consumption.
■ The diameter of pan bases should be the same size
as the hotplate. In particular, small saucepans on the
hotplate cause energy losses. Note that cookware
manufacturers often indicate the upper diameter of
the saucepan. This is usually bigger than the
diameter of the base of the pan.
■ Use a small saucepan for small quantities. A larger,
less full saucepan requires a lot of energy.
■ Always place suitable lids on saucepans. When
cooking without a lid, four times the energy is
required.
■ Cook with only a little water. This will save energy.
Vitamins and minerals in vegetables are preserved.
■ Switch to a lower heat setting in good time.
■ Use the residual heat. For longer cooking times, you
can switch the hotplate off 5-10 minutes before the
end of the cooking time.
Environmentally-friendly disposal
Dispose of packaging in an environmentally-friendly
manner.
5Installation and connection
Installation and connec t i on
'R QRW LQVWDOO WKH DSSOLDQFH EHKLQG D GHFRUDWLYH GRRU RU WKH GRRU
RIDNLWFKHQXQLWDVWKLVPD\FDXVHWKHDSSOLDQFHWRRYHUKHDW
Electrical connection
Only licensed specialists may connect the appliance.It
is important that you comply with the requirements of
your electricity supplier.
Any damage arising from the appliance being
connected incorrectly will invalidate the warranty.
Caution!
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
:Warning – Danger of death!
There is a risk of electric shock if you touch live
components.
■ Always make sure your hands are dry when you
touch or hold the mains plug.
■ Only pull out the mains cable by taking hold of the
plug and removing the plug; never pull it out by the
mains cable itself, as this could damage it.
■ Never unplug the mains plug when the appliance is
in operation.
Please note the following information and ensure that:
Notes
■ The mains plug fits the socket.
■ The cable cross section is adequate.
■ The earthing system is properly installed.
■ The mains cable is only replaced by a qualified
electrician (if this is necessary).Spare mains cables
can be ordered from our after-sales service.
■ No power strips/multi-way connectors or extension
cables are used.
■ If using a residual current device, only use one that
bears the mark z.
The presence of this mark is the only way to be sure
that it fulfils all the applicable regulations.
■ The mains plug can be accessed at all times.
■ The mains cable is not kinked, crushed, modified or
severed.
■ The mains cable does not come into contact with
heat sources.
For the after-sales service
Caution!
■ The appliance must be connected in accordance
with the data on the rating plate.
■ Only connect the appliance to an electrical
connection that meets the applicable provisions. The
socket must be easily accessible so that you can
disconnect the appliance from the electricity supply
if necessary.
■ Please ensure the availability of a multi-pin
disconnecting system.
■ Never use extension cables or multiple plugs.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning
used electrical and electronic appliances
(waste electrical and electronic equipment -
WEEE). The guideline determines the
framework for the return and recycling of used
appliances as applicable throughout the EU.
Loading ...
Loading ...
Loading ...