by
www.NutrichefKitchen.comwww.NutrichefKitchen.com
Homebrew
Mini Keg System
PKBRTP100PKBRTP50
UNIT OPERATION INSTRUCTIONS
PART ONE: SPEAR ASSEMBLY
1. Please clean mini-keg, cap, spear body, faucet and beer
hose with warm water and mild soap before use.
1. Spear Body
2. Cross-bar
3. Twist Tube
4. Pressure Relieving Ring
5. Nut
6. White Flow-control Block
7. Faucet
8. Faucet Knob
9. Regulator
10. Regulator Base
11. Regulator Knob
12. Gauge
13. 16g C02 Capsule
14. Beer Hose
2. Insert white ow-control block into cross-bar, it would
limit the beer ow and reduce over-foam.
3. Install faucet into spear body, make sure the connection is
proper and tight.
Remark: Improper connection would cause leakage of beer.
4. Cut beer hose according to keg height and insert into
spear, make sure hose can touch bottom of keg without
overlong or over short.
Remark: If beer hose is too short, beer would not be tapped
completely. But if beer hose is too long, it may crimp inside
the keg, because of incomplete tapping.
5. Check whether the regulator knob is in OFF position.
If not, please follow arrow mark instruction to turn the
regulator knob counter clockwise to the OFF position.
2. Insert white ow-control block into cross-bar, it would
limit the beer ow and reduce over-foam.
6. Turn in a new 16g C02 capsule with thread type of 3/8"-24
UNF, turn clockwise rmly into the regulator base.
Important: DON'T stop turning if you hear a slight gas leak
swish, nish turning it in all the way it seal properly.
PART TWO: TAPPING
1. Attach the spear system to the
keg. Make sure they are as tight
as possible to avoid lessening
or leakaging.
2. Connect the regulator to the spear system
Loading ...