Loading ...
Loading ...
Loading ...
SEAT REMOVAL
OPERATOR SEAT
To remove the operator’s seat, do the following:
1. Grasp one side of the seat near the rear edge.
2. Pull upward abruptly to disengage the under-seat fasteners.
3. Remove the seat.
PASSENGER SEAT
To remove the Passenger seat, do the following:
1. Pull the top of the seatback slightly rearward to relieve tension while pulling
the seat release latch upward.
2. When the latch releases, roll the seat assembly forward and lift the seat
away from the vehicle.
3. Always make sure the passenger seat is properly installed and securely
latched before operating with a passenger.
THROTTLE BODY/IDLE RPM
Idle RPM is preset by the manufacturer. If the engine idle speed is not
satisfactory, please see your POLARIS dealer or other qualified service facility
for adjustment.
THROTTLE CABLE FREEPLAY
1. Remove the four cover screws from the right handlebar control and remove
the cover.
2. With the handlebars straight ahead, place very light pressure on the throttle
lever. A gap of 2-3 mm should be visible between the throttle arm stop pin
and the throttle arm.
IF ADJUSTMENT IS NEEDED:
1. Locate the throttle cable adjuster. Squeeze the end of the rubber boot and
slide it back far enough to expose the inline cable adjuster locknut.
2. Loosen the adjuster lock nut.
3. adjust until 2-3 mm of freeplay is achieved between the stop pin and the
throttle arm. While adjusting freeplay, flip the throttle lever back and forth
repeatedly.
4. Place the transmission in PARK. Lock the parking brake.
5. Start the engine and allow the idle to stabilize. If necessary, tap the throttle
lever to ensure the idle speed settles.
137
MAINTENANCE
Loading ...
Loading ...
Loading ...