Loading ...
Loading ...
Loading ...
5
APPLIANCE MAINTENANCE
ATTENTION: IMPORTANT WARNINGS
For cookers resting on a base
ATTENTION: If the cooker rests on a base, take the measures necessary to prevent the cooker from sliding
along the support base.
For cookers with electric ovens
The unit becomes hot during use. Do not touch the heating elements inside the oven.
For cookers with electric ovens
ATTENTION: The accessible parts can become hot during use. Keep children away from the appliance.
For the food warmer compartment (or drop leaf in our case)
ATTENTION: The internal parts of the food warmer can become hot during use.
For glass doors
Do not use abrasive cleaning products or metal spatulas with sharp edges to clean the oven door’s glass
since this could scratch the surface and the glass could break.
Do not use steam cleaners to clean the appliance.
Replacing parts Before performing any maintenance operation, disconnect the appliance from the
gas supply and electricity network.
To replace parts such as knobs and burners, just remove them from the seats
without disassembling any part of the cooker.
To replace the oven bulb, just unscrew the protection cap that projects out inside the
oven.
Fig.2
WARNING: Before replacing the bulb, disconnect the appliance from the electric
power supply.
WARNING: The power cord supplied with the appliance is connected to that
appliance with an X type connection (in compliance with standards EN 60335-1, EN
60335-2-6 and subsequent amendments) for which it can be installed without the
use of special tools, with the same type of cord as the one installed.
If the power cord becomes worn or damaged, replace it based on the information
reported in types of power cords paragraph.
WARNING: If the power cord is replaced, the installer shall ensure that the ground
cable is longer than the phase cables and also shall comply with the warnings
regarding the electric connection.
To replace the power cable, lift the terminal board’s cover and replace the cable. To
access the terminal board in cookers with a 3x2.5mm² cable, the back panel on the
rear of the appliance must be removed. The power cord should be replaced only by
qualified personnel.
Before disposing of the packaging, please ensure you have removed all the
components.
Loading ...
Loading ...
Loading ...